nine hundred
Technical parameter table:
nine hundred and one
Tested after curing for 7 days at 25 ℃ and 55% relative humidity.
Product Description:
  Jiagu thermal conductive silicone rubber sealant, abbreviated as RTV-1 sealant, has the advantages of solvent-free, isocyanate free, anti pollution after curing, green environmental protection, excellent heat resistance and anti-aging ability. Suitable for thermal sealing of mechanical equipment and electronic components. This product meets environmental requirements and does not contain harmful substances in GB18583 "Limits of Hazardous Substances in Adhesives for Interior Decoration Materials". It complies with EU ROHS and REACH environmental standards.
  Product Features:
♦ Excellent thermal conductivity.
♦ Solvent free, PVC free, isocyanate free, non-toxic, neutral and environmentally friendly.
♦ Excellent thixotropy and extrusion properties, suitable for a wide temperature range.
♦ For most metals such as aluminum, painted steel plates, and PVC ABS,、 Polyester materials have excellent adhesive properties.
♦ Excellent weather resistance, aging resistance, and superior tensile and compressive recovery.
Curing mechanism:
  Jiagu thermal conductive silicone rubber sealant belongs to moisture absorbing curing adhesive. Once the colloid is opened, it absorbs moisture from the air and gradually solidifies from the surface to the deeper layers, becoming an elastic body. The higher the temperature and humidity, the faster the curing process; The curing speed is slow in low temperature and low humidity environments.
Application scope:
  Suitable for thermal sealing and bonding of various electronic components; HY583H is non corrosive to materials such as polycarbonate (PC) and copper.
Chemical resistant medium:
  The product can withstand freshwater, sewage, wastewater, calcium carbonate aqueous solution, cleaning agents, low acidity, corrosive aqueous solution, etc. for a long time, and can withstand mineral oil, vegetable oil, fat, fuel, etc. for a short time. It is not resistant to organic solvents, paint thinners, high concentrations of acid and alkali, etc.
usage method:
1. The joint surface should be free of oil stains, dust, impurities, etc;
2. Cut the glue nozzle into the required size and shape according to the process requirements;
3. Cut off the sealant seal, install the nozzle, and insert it into the glue gun;
4. Apply sealant evenly to the joint, with the thinnest part being greater than 1mm; When using a pneumatic gun, the air pressure should be controlled at 0.2~0.4Mpa;
5. After the product has dried, it can be repaired using traditional methods.
matters needing attention:
♦ Avoid construction in environments below 5 ℃ and humidity below 20%
♦ Pneumatic pressure must not exceed 0.5 Mpa. If exceeded, gas will enter the hard packaging tube and cause colloidal bubbles
♦ Due to the high solvent content in the coating, the adhesive surface may become soft. In order to achieve better appearance and performance, the adhesive should be applied after 24 hours of painting.
♦ For special chemical reactions, please contact our technical department
Packaging specifications:
Aluminum tube: 100 ml/tube, 100 tubes/box
Hard packaging: 310ml/tube, 50 tubes/box
Storage method:
RTV-1 sealant absorbs moisture and solidifies, and must be stored in a low-temperature dry environment with a shelf life of 9 months.