nine hundred
Technical parameter table:
nine hundred and one thousand nine hundred and two
Product Description:
 This product is a single component modified silicone material with advantages such as solvent-free, isocyanate free, anti pollution after curing, green and environmentally friendly, excellent heat resistance and anti-aging ability. Suitable for adhesive sealing of LED lighting fixtures. This product meets environmental requirements and does not contain harmful substances in GB18583 "Limits of Hazardous Substances in Adhesives for Interior Decoration Materials". It complies with EU ROHS and REACH environmental standards.
  Product Features:
♦ Solvent free, PVC free, isocyanate free, non-toxic, odorless, pollution-free, neutral and environmentally friendly.
♦ The surface has good paintability and is compatible with most paints. After the surface dries, it can be painted without affecting the curing speed.
♦ Excellent thixotropy and extrusion properties, suitable for a wide temperature range.
♦ No need for primer, it has excellent adhesion performance to metals, electrophoretic steel, ABS, PC, PP, PE and other materials.
♦ Excellent weather resistance, aging resistance, and superior tensile and compressive recovery.
Curing mechanism:
  & nbsp;& nbsp; Jiagu lamp adhesive sealant is formed by the hydrolysis and dealcoholization of silane and moisture in the air, followed by condensation, and belongs to moisture absorbing curing adhesive. Once the colloid is opened, it absorbs moisture from the air and gradually solidifies from the surface to the deeper layers, becoming an elastic body. The higher the temperature and humidity, the faster the curing process; The curing speed is slow in low temperature and low humidity environments.
Chemical resistant medium:
  & nbsp;& nbsp; The product can withstand freshwater, sewage, wastewater, calcium carbonate aqueous solution, cleaning agents, low acidity, corrosive aqueous solution, etc. for a long time, and can withstand mineral oil, vegetable oil, fat, fuel, etc. for a short time. It is not resistant to organic solvents, paint thinners, etc.
Application scope:
Sealing and bonding of LED car lights;
Sealing and bonding of LED solar lights;
Sealing and bonding of LED fluorescent lamps (T8 tubes);
Adhesive sealing of LED bulb lights, strip lights, and square lights;
Adhesive sealing for other application areas of LED.
usage method:
1. The bonding surface should be free of oil stains, dust, impurities, etc;
2. Cut the glue nozzle into the required size and shape according to the process requirements;
3. Cut off the sealant seal, install the nozzle, and insert it into the glue gun;
4. Apply sealant evenly to the joint, with the thinnest part being greater than 1mm; When using a pneumatic gun, the air pressure should be controlled at 0.3~0.5Mpa;
5. After the product has dried, it can be trimmed using traditional methods to remove excess glue.
matters needing attention:
♦ Avoid construction in environments below 5 ℃ and humidity below 20%
♦ Pneumatic pressure must not exceed 0.5 Mpa. If exceeded, gas will enter the hard packaging tube and cause colloidal bubbles
♦ Due to the high solvent content in the coating, the surface of the adhesive will become soft. In order to achieve better appearance and performance, coloring should be carried out after 24 hours of gel curing.
♦ For special chemical reactions, please contact our technical department
Packaging specifications:
Plastic pipe: 300ml/tube, 50 tubes/box
Plastic bucket: 2.6L/bucket 6 barrels/box
Plastic bucket: 25kg/bucket
Storage method:
This product absorbs moisture and solidifies. It must be stored in a low temperature (below 27 ℃) and dry environment (relative humidity below 30%), with a shelf life of 6 months.